1x hydraulic switch HPS3-BL. For monitoring up to 3 hydraulic functions. Run-on time 8 seconds. (CTI). For controlling the hydraulic pump signal via the drive controller or PS16oT. Version for brushless motors! The PS16oT can be found here in the shop under item number 9140. HPS3 is a control unit that controls a BL hydraulic pump depending on up to 3 hydraulic servos. If one of the up to 3 hydraulic servos is controlled by more than 16% from the rest position, the HPS3 starts a hydraulic pump signal. This signal controls the hydraulic pump motor via any drive controller or a PS16oT module. The motor starts immediately (full throttle) and for as long as the request is pending - plus 8 seconds run-on. After that, the BL pump motor switches off again. The pump motor does not have to run continuously, but only when there is a real need.

1x hydraulic switch HPS3. For monitoring up to 3 hydraulic functions. Run-on time 8 seconds. (CTI). For controlling the hydraulic pump signal via the drive controller or PS16oT. Version for brush motors! The PS16oT can be found here in the shop under item number 9140. HPS3 is a control unit that controls a hydraulic pump depending on up to 3 hydraulic servos. If one of the up to 3 hydraulic servos is controlled by more than 16% from the rest position, the HPS3 starts a hydraulic pump signal. This signal controls the hydraulic pump motor via any drive controller or a PS16oT module. The motor starts immediately (full throttle) and for as long as the request is pending - plus 8 seconds run-on. After that, the pump motor switches off again. The pump motor does not have to run continuously, but only when there is a real need.