1 control electronics THOR 2/xxx for 10-12V for electric lifting cylinders. (678) With BEC for self-supply! For SINGLE operation. 15x12x4,5mm, CTI product. The THOR2/xxx is a current measuring controller. It measures the current while the motor is running using a 0,1 ohm measuring resistor. If the current is higher than the maximum current set in the software, the software switches the motor off. The motor can then no longer be started in this direction of rotation until a breakaway algorithm in the opposite direction of rotation has been run through. This algorithm is triggered by normally starting the motor in the other direction of rotation and usually runs unnoticed by the operator. The current limit for this shutdown and reversal algorithm corresponds to a number internal to the software. This number must be selected depending on the motor used and the operating voltage. The higher this number, the later the blockage detection occurs.The THOR2 controls the motor speed continuously forwards and backwards. The current software version is only designed for 10 NiMH/NiCd cells or 3 Li-cells.The current measurement function was tested from 9,0 to 14,0 volts. BEC supply for receiver:The THOR2 has its own 5 volt supply, which can also be used for a receiver.Other servos should not be supplied via this, however, as this can affect the current measurement.

Control electronics THOR 2/yyy for 10-12V for electric lifting cylinders. (BCD). With BEC for self-supply! For parallel operation 15x12x4,5mm, CTI product. When 2 lifting cylinders are operated in parallel (e.g. swing arm of a wheel loader), BOTH cylinders are controlled by ONE parallel controller! The THOR2/xxx is a current measuring controller. It measures the current while the motor is running using a 0,1 ohm measuring resistor. If the current is higher than the maximum current set in the software, the software switches the motor off. The motor can then no longer be started in this direction of rotation until a breakaway algorithm in the opposite direction of rotation has been run through. This algorithm is triggered by normally starting the motor in the other direction of rotation and usually runs unnoticed by the operator. The current limit for this shutdown and reversal algorithm corresponds to a number internal to the software. This number must be selected depending on the motor used and the operating voltage. The higher this number, the later the blockage detection occurs.The THOR2 controls the motor speed continuously forwards and backwards. The current software version is only designed for 10 NiMH/NiCd cells or 3 Li-cells.The current measurement function was tested from 9,0 to 14,0 volts. BEC supply for receiver:The THOR2 has its own 5 volt supply, which can also be used for a receiver.Other servos should not be supplied via this, however, as this can affect the current measurement.