Bellows, soft, (as a dummy air suspension). Made of rubber, suitable for light models to 5kg. (2 piece). Height 21mm, diameter 20mm. (500907357)

Air bellows, hard, (as air suspension dummy). Made of rubber, suitable for heavy models. (2 pieces). Height 21mm, diameter 20mm. 500907358

Air bellows (as air suspension dummy) Made of rubber, suitable for models in scale 1/16 to 1:13,6. (2 pieces). Height 21/25mm, diameter 26mm. For models up to 10kg. 500907373

1 air suspension conversion kit for Tamiya chassis. Set for 1 axle. No new holes need to be drilled in the frame! The set consists of:2 air cushions (rolling bellows)2 axle supports, aluminum, black anodized2 holders for longitudinal supports, aluminum, black anodized2 longitudinal supports, aluminum/brass, rotatably mountedThe upper part of the air cushions is made of aluminum (black anodized). The middle part is rubber (hollow) and adapts to the suspension. (Works without springs). The lower part is made of aluminum and presses into the rubber when loaded - like the original.The air cushion is mounted with the lower fastening screw of the frame and rear cross member (C20). The fastening eyes on the longitudinal control arms, which are used to attach to the holders, are movable and thus rotate 360 ​​degrees - an advantage for the suspension!The axle is placed in the axle support from above and screwed in. The angles for the shock absorbers and the shock absorbers are no longer required.

The total height of the system can be adjusted using the 3 aluminum foot sections supplied with different heights! Scope of delivery: 2 air bellows (rubber dummies) 2 head sections (aluminum) for fastening under a support 2 head sections (aluminum, black anodized) with fastening flag for screwing to the side of the frame longitudinal support 3 sets (2 each) of foot sections of different heights (5,5mm, 7mm, 8mm) made of aluminum threaded piece and nuts The spring bellows are supplied assembled. To replace the head or foot sections, only 1 nut needs to be loosened. The different foot sections allow installation heights of 25 - 32mm to be set (unloaded).