VAT included plus shipping and handling
Immediate dispatch, delivery time is about 1-4 days **
- Article no.: 10770
This drive fits the Goldhofer trailer article 6978!
The drive set is mounted on the model and controls the ramps with a geared motor. The upper and lower end position is secured with one limit switch each! The limit switches are already wired ready for installation. All you have to do is solder the cables to the motor! For operation, a battery voltage of 7,2-9.6 Volt is provided. If operation must be carried out with a higher voltage (eg 12V), you can use a speed controller and operate it with only approx. 60% "servo travel".
As a big highlight, the ramps can still be moved sideways! Although this is not possible remotely, the semi-trailer can be used by very small models!
Delivery:
- Geared motor
- worm gear (worm pre-assembled on motor)
- Limit switch, pre-assembled and wired
- new, continuous shaft for ramps
- Side covers for shaft
- new ramp holders, suitable for new shaft (laterally movable!)
- Gear housing base plate (acts as a drilling template)
- Gearbox cover
- Instructions, screws, cables
Operation is possible with a polarity reverser switch or speed controller (not included!)
Cruise control: Thor4 (article 3020)
Polarity reverser: Article 9856, 3569.
This ramp drive only fits the Goldhofer semi-trailer (article 6978).