VAT included plus shipping and handling
Immediate dispatch, delivery time is about 1-4 days **
- Article no.: 11440
Ramp drive for Goldhofer trailer TU-4 (Carson). With motor for 7,2-9,6V.
Ramp drive suitable for the Goldhofer-TU4 low loader trailer from Carson (article 10831 - not included).
The drive set is mounted on the model and controls the ramps with a geared motor. The upper and lower end position is secured with one limit switch each! The limit switches are already wired ready for installation. All you have to do is solder the cables to the motor! For operation, a battery voltage of 7,2-9.6 Volt is provided. If operation must be carried out with a higher voltage (eg 12V), you can use a speed controller and operate it with only approx. 60% "servo travel".
As a big highlight, the ramps can still be moved sideways! Although this is not possible remotely, the semi-trailer can be used by very small models!
Delivery:
- Geared motor
- worm gear (screw pre-assembled on shaft)
- Limit switch, pre-assembled and wired
- new, continuous shaft for ramps
- Side covers for shaft
- new ramp holders, suitable for new shaft (laterally movable!)
- Gear housing base plate (acts as a drilling template)
- Gearbox cover (left and right)
- Instructions, screws, cables
Operation is possible with a polarity reverser switch or speed controller (not included!)
Cruise control: Thor4 (article 3020)
Polarity reverser: Article 9856, 3569.