EasyBus lighting system semi-trailer KIEB 6 / 2 / 2

EasyBus lightbox semi-trailer KIEB 6 / 2 / 2 for Tamiya or Carson semi-trailer with Euro taillight.

Tips & Tricks for installation:

Tipp1: The KIEB 6 / 2 / 2 can be supplied with power in three variants: via the battery connector, via a servo connection and the BEC of a connected travel controller or via a bus output and the BEC of a connected KMB.

Tipp2: After switching on, the red LED of the KIEB 6 / 2 / 2 flashes twice. After that, the LED should go out as long as an IR connection is established. If the red LED flashes irregularly, the gain should be better adjusted with the potentiometer.

Tipp3: It is possible to check the transmission of the IR transmitter by pointing the transmitter diode at the camera of a mobile phone. If there is a purple flickering in the camera app, the diode sends.

Highlights & Details

Plug & Play solution (connect and drive)

One motor output for semi-trailer supports or spindle drives

Two freely adjustable servo outputs (eg for steerable trailing axle)

Receives ALL information ...

... all lighting functions and switching states ...

... but also all proportional functions ...

... up to 1.5m far or up to an angle of 90 °

Lighting boards can be connected directly via EasyBus

Technical data

Length (excl. Pin length) 60mm

Width 40mm

Height 12.5mm

Voltage 4-5 cells (max 8V)

BEC 5V (1A)

switching outputs

Servo outputs 2

Motor outputs 2

EasyBus outputs 3

Bridgeable route up to 1.5m

Maximum angle approximately 90 °

What's in the box

KIEB 6 / 2 / 2

2x Euro rear light board

2x machined Euro housing

receiver diode

If the electronics are supplied by a rechargeable battery, we recommend (depending on the space available) these items:

Item 7110 with 4,8V

Item 11121 with 4,8V

Item 7823 with 4,8V

Item 7745 with 4,8V

Item 7549 with 6V

Item 6457 with 6V