EasyBus lighting system KLM 4 / 16 TAMIYA MB Actros 1851

EasyBus KLM 4 / 16 lighting system for Tamiya Mercedes-Benz Actros 1851

The lighting system for the TAMIYA MB Actros 1851 with the new KLM 4 / 16, ready-to-install lighting boards and integrated infrared transmitter.
The lighting boards are simply inserted from the back into the light chambers and hold by press fitting.
The system is controlled by a KLM 4 / 16, which is compatible with ordinary forward / reverse cruise controls (with or without a separate brake), cruise control and all sound modules.

The light functions can be controlled either with our control pad or in many other ways, details can be found in the online manual.
This starter kit includes a complete lighting system for the Actros 1851 by TAMIYA and consists of two front lighting boards with wired LEDs for the side indicators, underride protection and parking lights, and a KLM 4 / 16 light assistant.
The lighting boards are connected directly to the KLM 4 / 16 and can also be configured with our ControlPanel power plant. Brightness, flashing speeds, but also the basic functionality (eg: should be switched on the output, the high beam) can be set separately for each output. You will find information about this

Highlights & Details

KLM 4 / 16 (4 servo inputs, 16 switching outputs, 5 bus outputs)

Ready to install lighting boards

Plug & Play solution (connect and drive)

Compatible with all sound modules

Compatible with all travel controllers

Compatible with Tamiya MFU

Expandable with different lighting boards

Extendable with infrared for trailer lighting

Adaptable to the prototype to the smallest detail via PC

No programming skills required

downzuloaden software free - PC

Technical data

Power supply:

via receiver power supply (BEC of the travel controller)

Max. Power consumption 20mA per device and 20 mA per LED

LEDs front (per side):

1 x 3mm yellow

1 x 3mm white

2 x 5mm white

2x 3mm white wired

1x 3mm yellow wired

Ultra bright high power LEDs

Additional outputs front 3 with each 180Ohm resistor

LEDs rear (per side):

1x 5mm red

1x 5mm yellow

1x 3mm white

1x 3mm red

Ultra bright high power LEDs

Additional rear outputs per 1 with 180Ohm resistor

What's in the box

Lighting assistant KLM 4 / 16

four ready-to-install lighting boards (2x front, 2x rear)