EasyBus lighting system KLM 4 / 16 TAMIYA Scania R470 and R620

EasyBus lighting system KLM 4/16 for Tamiya Scania R470 and R620.

The lighting system for the TAMIYA Scania R470 and R620 with the new KLM 4 / 16, ready-to-install lighting boards and integrated infrared transmitter.
The front lighting boards are simply inserted from the back into the light chambers and hold by press fitting. For the rear taillights, the original webs must be removed and a hole drilled for the cable entry. The boards are glued including the included dividing grid in the processed lamp body. The dividing grids mentioned make the original subdivision into five chambers and at the same time provide receptacles for the lamp glasses.
The system is controlled by a KLM 4 / 16, which is compatible with ordinary forward / reverse cruise controls (with or without a separate brake), cruise control and all sound modules.

The light functions can be controlled either with our control pad or in many other ways, details can be found in the online manual.
This starter set includes a complete lighting system for the Scania R470 and R620 from TAMIYA and consists of two front lighting boards and two rear lights, as well as a light assistant KLM 4 / 16.
The lighting boards are connected directly to the KLM 4 / 16 and can also be configured with our ControlPanel power plant. Brightness, flashing speeds, but also the basic functionality (eg: should be switched on the output, the high beam) can be set separately for each output. You will find information about this

Highlights & Details

KLM 4 / 16 (4 servo inputs, 16 switching outputs, 5 bus outputs)

Ready to install lighting boards

Plug & Play solution (connect and drive)

Compatible with all sound modules

Compatible with all travel controllers

Compatible with Tamiya MFU

Expandable with different lighting boards

Extendable with infrared for trailer lighting

Adaptable to the prototype to the smallest detail via PC

No programming skills required

downzuloaden software free - PC

Technical data

Power supply:

via receiver power supply (BEC of the travel controller)

Max. Power consumption 20mA per device and 20 mA per LED

LEDs front (per side):

yellow: 1x 3mm

white: 2x 3mm, 2x 5mm

Ultra bright high power LEDs

Additional outputs front 3 with each 180Ohm resistor

LEDs rear (per side):

red: 4x SMD 1206

yellow: 1x SMD 1206

white: 1x SMD 1206

Ultra bright high power LEDs

Additional rear outputs per 1 with 180Ohm resistor

What's in the box

Lighting assistant KLM 4 / 16

four ready-to-install lighting boards (2x front, 2x rear)