Model Suspensions

1x semi-trailer for Carson Stone Master semitrailer. For operating voltage 7,2V. Trailer support suitable for the Carson Stone Master semi-trailer. (Semi-trailer), Article 8472 (not included). The attachment to the frame is done with the ...

1x long position leaf spring (long). 6mm wide, about 69mm long. 2 holes 3mm at a distance of 10mm to the axle. From low loader, Wedico. 1 piece. (Feder1 part 32).

1 pair of fenders Alu, smooth, for one axle with twin wheels. Drilled. Total length 92mm. Width 44mm. With holders and small parts. 1 pair of fenders.

CARSON Alu Traverse / underrun protection for Tamiya Arocs 3348. The rear crossbar and the underride guard have been optimized to use the lift to maintain the clutch level. As soon as a raise kit is used, ...

Mudguard set quarter for semi-trailers in Tamiya scale. Inclusive fender holder.

Saddle plate SAF, Tamiya scale material plastic

SandMaster lift kit for Tamiya Mercedes-Benz Arocs 3348. Elevation to 10mm. A cardan shaft with length compensation is required.

CARSON lift kit for all Tamiya 3chs tractors. Also fits with Arocs 3348. Compatible with Tamiya axles and Carson self-locking axles. + 8mm higher lift.

1 pair of fenders Alu, smooth, for one axle with single tires. Drilled. Total length 92mm. Width 34mm. With holders and small parts. 1 pair of semi-circular fenders.

Stem control ST.80 (1,5A). For 12V. These support systems (12V version) can be used for all electrically operated trailer rests or ramps. Optionally the article 10676 is available - this allows the ...

Stem control ST.80 (1,5A). For 7,2V. These support supports (7,2V version) can be used for all electrically operated trailer rests or ramps. The 10676 article is available as an option ...

Switch for column control ST.80. This selector allows the manual operation of trailer supports when the column controls 10675 (12V) or 10681 (7,2V) are used. The switch can be used in any desired location on the ...

1x Alloy clutch lever plate. 2 / 3-axis. Alu. Set contains 1x clutch lever plate made of aluminum and required mounting material. The plate can be exchanged for the plastic plate from the kit of all 2 and 3-axis ...

1 pallet box, Tamiya-size kit milled aluminum parts. Flaps to open. With 6 Euro pallets. Dimensions approx .: Length 180mm, width 190mm, height 70mm. Suitable for frame width 96mm 500907379