VAT included plus shipping and handling
Immediate dispatch, delivery time is about 1-4 days **
- Article no.: 9103
1x hydraulic switch HPS3. For monitoring up to 3 hydraulic functions. Run-time 8 seconds. (CTI). For controlling the hydraulic pump signal via the travel controller or PS16oT.
Version for brushed motors!
The PS16oT is here in the shop under the Article. find 9140.
HPS3 is a control unit that drives a hydraulic pump in dependence of up to 3 hydraulic servos.
If one of the driven up to 3 hydraulic servos by over 16% from the rest position, the HPS3 start a hydraulic pump signal.
This signal controls the hydraulic pump motor via any travel controller or a PS16oT module. The engine starts immediately (full throttle) and as long as the request is pending - plus 8 seconds. The pump motor then goes out again.
Thus, the pump motor does not run continuously, but only when also demand really exists.