ScaleART Commander Multi-Receiver Unit CM-5000

ScaleART Commander Multi-Receiver Unit CM-5000 The Multifunctional Room ... special operating modes for commercially available servos are tailored to the requirements of functional model construction. There is, for example, a mode for operating a servo such as a hydraulic cylinder: when the stick is released, it remains in the current position. This can also be removed by means of an interval switch to the windshield wiper. The speed of rotation of servos (also in normal operation) is adjustable in order to achieve particularly realistic motion sequences. By means of freely programmable mixers, special functions can be implemented, such as the meaningful steering of tracked vehicles, final shutdown of drives, delayed response or arbitrary path curves.

The optional programmable controller (PLC) integrated in the receiver also allows the individual realization of sequences which otherwise would only be possible with complex additional modules.

The control center for the light bus system is permanently integrated into all Scaleart receivers. Individualization is thus possible, such as a programmable flashing clock and automatic turn signal reset after turning, adjustable response thresholds for cornering and turning light, or between vehicle lighting and operating conditions.

The CM-5000 offers the complete equipment: connections for 16 servos, two temperature or pressure sensors and the bus light system. An integrated position sensor determines the slope or slope as well as the lateral inclination. For the operation of hydraulic pumps or auxiliary drives there is a regulator which can withstand 4 Ampere. In addition, the receiver can monitor the power supply of the whole model: an integrated sensor measures the current drawn from the battery and determines the used capacity. Also available is an infrared output, which allows for comfortable operation with trailers or trailers which have a lighting system from Scaleart or Robbe. The CM-5000 measures 63x41mm, the remote mountable antenna 40x17mm. If required for more connections, these receivers can be operated up to 8 on a common antenna in the model. The RF antenna is required!

Functional overview Multi-receiver unit CM-5000:

• Servosteckplätze: 16
• Can be used for switching functions: 16
• Can be used as an input: 8
• Functional Components (Mixers): 16
• Control light bus: yes
• IR output: Compatible with Robbe and Scaleart
• Integrated controller for auxiliary drives: Up to 3 Ampere, with overcurrent, short circuit and temperature protection
• Control of MULTITWITCH modules: 1 compatible with Graupner, Robbe and ScaleART
• Measurement battery voltage: yes
• Measurement Current consumption: yes
• Battery management with reverse polarity protection: loadable up to 12 Ampere, maximum operating voltage 18 Volt
• Additional sensor connections: 2
• Location sensor: inclination and incline
• Adjustable alarm thresholds: Individual minimum or maximum values ​​for all measured values
  monitored
• Mixer for chainsaws: yes
• End switch off via sensor: Yes
• Undervoltage protection: yes
• Regulator current limit: yes
• Sequential transmission control: up to 4 gears
• Free weaving template: yes
• Brake light function: yes
• Smoke generator control: yes
• Resettable operating hours counter: 4
• Servostellzeit adjustable: 0-20 seconds
• Adjustable servo: 0-200% separated on the right and left
• Hydraulic simulation for servos: yes
• Programmable sequence control: yes *
• Password protection: Separate for operation and configuration
• Power supply: BEC or Fahrakku, 4,8 to 18 Volt
• Bus-capable (several evaluators in the model): yes
• Software update possible in the model: yes
• Dimensions: 63x41mm
  
  * Sequence control configurable only with Commander SA-1000 / SA-5000