ScaleART Multi-Receiver Unit CM-1000

ScaleART Commander Multi-Receiver Unit CM-1000. Without HF antenna module.

The multifunctional talent... special operating modes for commercially available servos are tailored to the requirements of functional model building. For example, there is a mode to operate a servo like a hydraulic cylinder: when you release the stick, it stays in the current position. This can also be expanded to a windscreen wiper using an interval switch. The rotational speed of servos (also in normal operation) can be adjusted in order to achieve particularly realistic movement sequences. Special functions can be implemented via freely programmable mixers, such as the correct steering of tracked vehicles, limit switch-off of drives, delayed response or any path curves.

The optional programmable controller (PLC) integrated in the receiver also allows the individual realization of sequences which otherwise would only be possible with complex additional modules.

The control center for the light bus system is permanently integrated into all Scaleart receivers. Individualization is thus possible, such as a programmable flashing clock and automatic turn signal reset after turning, adjustable response thresholds for cornering and turning light, or between vehicle lighting and operating conditions.

The receiver CM-1000 is designed for models with a smaller range of functions. It offers 10 connections for servos and can directly control the light bus system via an adapter cable. The whole unit mistakes only 40x28mm. The RF antenna is required!

Functional overview Multi-receiver unit CM-1000:

• Servosteckplätze: 10
• Can be used for switching functions: 8
• Can be used as an input: 1
• Functional Components (Mixer) 8
• Control Light bus: no
• Control of MULTITWITCH modules: 1 compatible with Graupner, Robbe and ScaleART
• Measurement battery voltage: yes
• Adjustable alarm thresholds: low battery voltage
• Hydraulic pump control: max. 16 functions
• Mixer for chainsaws: yes
• Undervoltage protection: yes
• Sequential transmission control: up to 3 gears
• Free weaving template: yes
• Brake light function: yes
• Resettable operating hours counter: 1
• Servostellzeit adjustable: 0-20 seconds
• Adjustable servo: 0-200% separated on the right and left
• Hydraulic simulation for servos: yes
• Password protection: Separate for operation and configuration
• Power supply: BEC or Fahrakku, 4,8 to 18 Volt
• Bus-capable (several evaluators in the model): yes
• Software update possible in the model: yes
• Dimensions: 40x28mm